Table of Contents
Advertisement
Connections
Controller MV4K - Connections
Attention!
In the Figure the correct connection and attachment of wires to the controller were presented.
It is mandatory to attach the cables to the holes in the housing. Such a solution protects form pulling the plug from the sockets.
The individual cable cores should be insulated, tinned or crimped with the use of the end sleeve (as shown).
It is a protection against accidental short circuit of the cores and possible damage of the controller.
Accesories
To the controller one can connect additional accessories such as footswitch and elevation motor cover sensor.
Input of the elevation cover sensors is optional and it not included in the standard equipment of the device.
More avaliable accesories you can find on our website www.mains.pl
Mechanical sensors
Inductive sensors
Signal lamps
Footswitches
controller: Mv4k
10
MAINS S.C. E.M.Wosińscy Brzeziny 95-060 ul. Słowackiego 12, tel/fax: 48 46 8752 777 www.mains.pl; mains@mains.pl
Advertisement
Table of Contents
