Defaults - netAlly LinkRunner AT 1000 User Manual

To Save a Report
1 Select Tools > Manage files.
2 Select Save Report. The current measurement data is now
saved to the report filename shown at the bottom of the
screen. To change the filename, select Edit.
P
3 Select Save or .
To Rename a File 1 Select Tools >
Manage files.
2 Select Rename file.
3 Highlight either the Report or Profile folder.
4 Highlight the file, then press
5 To edit the filename, press
• To delete characters in the filename, press
• To add characters to the filename, use
character, then press
• To move the cursor in the filename, highlight the filename,
then press .
6 To rename the file with the name you made, press
press Rename.
L
.
Edit.
Delete.
to highlight a
L
.
To Delete a File 1 Select Tools >
Manage files.
2 Select Delete file.
3 Highlight either the Report or Profile folder.
4 Highlight a file, then press
5 Press
Restore Factory Defaults
Restores any configuration changes to the following LinkRunner AT
factory defaults.
•
IP Configuration: IPv4: DHCP
IPv6: Disabled
•
VLAN/MAC/Proxy Configuration:
VLAN: Disabled
VLAN ID: 0
Priority: 0
User Defined MAC: Disabled
MAC Address: LinkRunner MAC address
Proxy: Disabled
•
AutoTest Configuration:
Save, then
Continuous Mode: On
Target: none
L
.
Delete.
Additional LinkRunner Tools
22