Table of Contents
Advertisement
Troubleshooting
Preparatory operation
The camera does not turn on or function buttons do not respond.
Possible cause
The power is off.
The battery is drained.
The battery is temporarily
unable to function because
of the cold.
The camera is connected to
a PC.
Shooting
No picture is taken when the shutter button is pressed.
Possible cause
The battery is drained.
The camera is in the
playback mode.
The flash has not finished
charging.
The card is full.
The battery ran out of power
during shooting or while the
images were being written to
the card. (The monitor turns
off after BATTERY EMPTY
is displayed.)
12
The memory gauge on the
monitor is full.
There is a problem with the
card.
The monitor goes off.
Possible cause
The power is off.
194
Corrective action
The camera automatically turns off if it is not
operated for a certain period of time. Press the
POWER switch to turn the camera on.
Charge the battery.
Warm the battery by putting it in your pocket for
a while.
The camera does not operate while it is
connected to a PC. Disconnect the camera
from the PC.
Corrective action
Charge the battery.
Set the mode switch to any position except
Remove your finger from the shutter button,
and wait until the
mark stops blinking. Press
the shutter button again.
Erase unwanted images or insert a new card.
Before erasing, download important images to a
PC.
Charge the battery. (Wait until the card access
mark turns off when blinking.)
Wait until there is room in the memory gauge.
Refer to "Error codes".
Corrective action
The camera automatically turns off if it is not
operated for a certain period of time. Press the
POWER switch to turn the camera on.
Ref. Page
P. 30
P. 27
—
—
Ref. Page
P. 27
.
P. 30
—
P. 93
P. 27
P. 23
P. 192
Ref. Page
P. 30
Advertisement
Table of Contents
