Troubleshooting - Olympus CAMEDIA C-3030ZOOM Instructions Manual

TROUBLESHOOTING

OPERATING PROBLEMS
The camera does not work.
1
The power is OFF.
[ Set the Mode dial to turn on the power. (P. 30)
2
The batteries are loaded incorrectly.
[ Reload the batteries correctly. (P. 22)
3
The batteries are exhausted.
[
Replace the batteries with new ones. (P. 22)
4
The batteries are temporarily unable to function.
[
Keep the batteries warm while using the camera.
5
Power has shut off to conserve battery consumption.
[
Operate the shutter button or the zoom lever.
6
It is connected to a personal computer.
[
The camera will not operate while it is connected to a personal
computer.
No picture is taken when the Shutter release button is pressed.
1
The flash has not finished charging or the previous picture is being
written into the card.
[
Remove your finger from the Shutter release button and wait until
the Green lamp or the Orange lamp stops blinking. (P. 42/58)
2
There is a problem with the card.
[
See the Error code chart. (P. 221)
3
The card is full.
[
Replace the card, delete unwanted pictures or transfer the data to
a computer and delete all of the pictures. (P. 26/107/114/174 ~ 178)
4
The batteries ran out.
[
Replace the batteries with new ones. (P. 22)
5
The battery power is low.
[
Replace the batteries with new ones. (Do not open the Battery
compartment cover when the Card access lamp is blinking.)
(P. 22)
6
The buffer memory is full.
[
Wait until there is room in the buffer. (P. 45/123)
7
A write-protect adhesive seal is placed on the card or there is no card
in the camera.
[
Insert a new card in the camera. (P. 26)
8
The Mode dial is set to
[
Set the Mode dial to P, A/S/M or
216
.
. (P. 31)