Table of Contents
Advertisement
Appendix 2: Troubleshooting
Operational problems
Cannot operate the camera, monitor and control panel blank.
Problem
White mark on the power switch at the ON
position?
Has the camera been left idle for over 1 hour
with the power on?
Have the batteries been inserted correctly?
Are the batteries dead?
Have you been using the camera in cold
weather?
192
Solution
Move the power switch toward you and
position it at the ON position.
If the camera remains in the sleep mode for
over 1 hour, it will power off automatically. Move
the power switch to the OFF position and then
move it back to the ON position to switch the
camera on.
Remove the batteries and make sure that their
polarities have not been reversed. Re-insert
the batteries correctly.
Insert fresh batteries. If you are using the
lithium polymer battery or Ni-MH battery,
recharge it.
Using the camera at low temperature could
temporarily diminish the capacity of the
batteries. Warm some new batteries in your
pocket and insert them in the camera.
Page
© 28
© 136
© 16
© 16
Advertisement
Table of Contents
