BAH Series Manual
Heater Mounting
Improper suspension of the infrared heater may result in collapse and being crushed.
Always suspend from a permanent part of the building structure that can support the total
force and weight of the heater.
Failure to maintain minimum clearances to combustibles may result in fire and/or explosion,
property damage, serious injury, or death. Always maintain minimum clearances and post
signs adjacent to heaters controller. Signs should state the hazards for the particular
application and be legible to the building occupants. Consult the factory or a factory
representative for additional information on signage compliance.
The heater can be suspended with chains or bracket mounting. When chain mounting, the off-center holes
may be used to adjust the mounting angle by 20°. Optional brackets are available for wall or ceiling surface
mounting. Consult all applicable codes before installation.
The heater must be level from side to side and may be 0° to 20° on horizontal. Refer to figures 2.2 and 2.3.
Figure 2.2
•
Heater Dimensions in Inches (cm)
6.375"
(16)
Chart 2.2
•
Physical Dimensions in Inches (cm)
Model No.
A
BAH-18
18
" (46)
BAH-25
25
" (63)
BAH-35
35
" (89)
BAH-45
45
" (114)
BAH-60
60
" (152)
WARNING
!
6.75"
(17)
14.25"
(36)
2.0
Mount Heater Level
- Side to Side -
Figure 2.3
•
Heater Dimensions
11
Installation
•
Heater Mounting
A
20°