2.0
Installation
•
Mounting Bracket Assembly
Mounting Bracket Assembly
Attach the mounting brackets to the top end caps. On each end, place (1) 1/4" x 3/4" bolt through the
1
bottom hole of the mounting bracket and through the top hole of the end cap. Place (1) 1/4" lock washer
and (1) 1/4" lock nut on each bolt. Do not tighten completely. Refer to figure 2.4.
NOTE: The mounting brackets are NOT required for chain suspension.
Adjust mounting brackets to desired mounting angle.
2
Once desired mounting angle is achieved tighten lock nuts to bolt.
3
Figure 2.4
•
Mounting Bracket Assembly
1/4" x 3/4" Bolt
14
BAH Series Manual
1/4" x 3/4" Bolt