Step 4 Install Ibm Ata 133 Raid Controller - IBM ATA 133 User Manual

Step 3 Set Jumpers,
IBM ATA 133 RAID controller layout The following diagram displays the headers and connectors on the
RAID controller.
S eco n da ry C h an ne l

Step 4 Install IBM ATA 133 RAID Controller

Select a 3.3 V or 5 V PCI slot and align the RAID controller card bus connector to the
slot. Press down gently but firmly to make sure that the card is properly seated in the slot.
The bottom edge of the controller card should be flush with the slot.
Insert the card into a PCI slot as shown below. Attach the controller to the computer
chassis with the bracket screw.
continued
J 1
Secondary LED J2
O ption
R Om
J 7
B racket S crew
Edge of
Motherboard
Pr im a ry C h an ne l
J3
J4
C ontroller
P rim a ry LE D J5
32-bit slots
Chapter 4 Hardware Installation
D rive
Ac tivity
LE D J 6
17