xsto CT420SC Operation Manual page 19

3.4.2 Track walks on flat ground
At the bottom of CT420SC has catser
for moving on flat ground.
the loading board to the smallest
angle, which will enable the casters
touch the ground.
At the same time, press the rear
supporting wheel button to extend
the rear supporting wheel till the
wheel touch the ground and be
horizontal with the loading board.
This way can be applied on flat
ground ONLY.
Warning ： When the slope of
the ground is bigger than 5°, it is
forbidden to use the flat ground
model by using the caster to move!
The CT420SC can move on flat ground
by crawler tracks. Switch to the
loading board
mode, raise the loading board to an
angle till the crawler tracks touch the
ground, then the operator can move
the machine
joystick.
This way is applied to short distance
walk or on uneven road surfaces.
Adjust
manual operation
by controlling the