Product Installation - Haier HXC-106 Operation Manual

Name
Model
Exterior dimensions
(W x D x H) (mm)
Interior dimensions
(W x D x H) (mm)
Eff ective volume
Door
Insulation
Compressor
Shelves / Drawer 5 shelves / 20 baskets
Load
Refrigerating Method
Exterior / Interior
Condenser/Evaporater
Temperature Control
Refrigerant
Interior light
Net weight
Temperature range
Voltage
Rated power / current
Noise Level
Foaming Agent
Climate Type
Anti-shock Safety
Classifi cation
Power connection type
USB function / temperature
recorder
High-low temperature alarm, sensor fault alarm, power failure alarm,
Alarm system
Battery duration for alarm
system
Rechargeable battery
Note: Climate Type ST means the temperature is 18 - 38℃ ,the relative humidity is up to 85%.Due
to continuous improvements, technical information on your refrigerator may be diff erent from herein
published.
Blood Bank Refrigerator
HXC-358 HXC-358B
720x690x1730
620x490x1160
358L
Glass door with electric heat
CFC-Free foamed-in-place urethane
High Quality Hermetically sealed compressor
5 Drawers
Max:25kg per shelf
Forced convection cooling
Scratch resistant painted steel / Stainless steel
Fin tube type
Microprocessor controlled
R134a 420g
LED 3W
158kg 165kg
4±1℃
220V-240V~/50Hz/60Hz
460W/3.0A
43dB(A)
HFO-1233zde
ST
I
Y
Optional / Standard
low battery alarm and door opening alarm
48 hours (when battery is fully charged)
DC12V Rechargeable lead-acid battery
34

Product Installation

Installation environment
•Ambient temperature: 18℃ to 38℃ with exception of HXC-106/1308/1308B at 16℃ to 32℃ . Range
of 18℃ to 25℃ is ideal.
•Ambient humidity: below 85% RH .
•Avoid dusty and unstable areas for installation.
•Avoid mechanical swing or vibration.
•The refrigerator shall operate at an altitude lower than 2000m.
•Input voltage: Within rated voltage ±10%.
•Refrigerator units are not permitted to operate outdoors. Rough condition and
Caution
rainwater can cause electrical issues and hazardous conditions.
•It is prohibited to install the refrigerator outdoors. Electric leakage or shock may be
caused if the refrigerator gets wet by rainwater.
Installation site
The installation site shall meet following requirements for normal operation and best performance of
refrigerator:
•Do not install the refrigerator in a narrow and confi ned space as heat may be trapped to increase
ambient temperature. Additionally, a unit should not be installed in a space where the entry door way
is low to prevent an easy maneuver of the unit for maintenance and operation.
•The ground at the installation site shall be solid and fl at.
•The fl oor for the installation site should be solid and fl at. It should also be well ventilated and free
from direct sunshine.
•The power outlet for the refrigerator must be a dedicated power outlet. The power plug must be
plugged in to the outlet securely.
•Do not twist or jam the power cord.
•If the power cord needs to be extended, the cross section area of the conductor in the extended line
should be no less than 3 squared millimeters and no longer than 3 meter.
•Inspect the operating voltage range before operation. If the voltage supply is unstable, install a
voltage stabilizer of 4000W or greater to ensure the supply voltage is within 10% of the rated voltage
supply.
•The refrigerator must be grounded reliably.
•Check the integrity of the socket ground before power up. If it is not grounded appropriately, repair
the wiring before installing the unit.
•If the socket is not provided with grounding wire, a new one shall be installed by engineering
technician.
•Do not ground the refrigerator through gas lines, water lines, telephone lines, or
Warning
lighting rods as these devices may cause electric shock and danger.
•The power plug and outlet should be located in a place where it can be accessed
easily and immediately in case of an emergency. Air vents must be free of obstruction.
7