Antennas And Radios; Supported External Antennas - Cisco Catalyst IW9167E Hardware Installation Manual

Antennas and Radios

Table 3: Supported SFP Modules
PID
GLC-SX-MM-RGD=
GLC-LX-SM-RGD=
GLC-T-RGD=
SFP-10G-LR10-I
SFP-10G-T-X
1
Note
Client data is passed to the network controller through the fiber connection via a fiber-capable switch or
controller. Configuration information can be found in the controller configuration guide of the switch or
controller you are using.
Antennas and Radios
The Cisco Catalyst IW9167E Heavy Duty Access Point configuration is:
• IW9167EH-x
The IW9167EH access point has eight N-type female connectors to support multiple antenna options, such
as the self-identifying antennas (SIA) on designated three SIA ports, dual-band antennas, and single-band
antennas. To see the list of supported antennas and the radio bands they operate at, see
Antennas, on page

Supported External Antennas

The following figure shows the antenna ports of the IW9167EH access point.
Cisco Catalyst IW9167E Heavy Duty Access Point Hardware Installation Guide
8
Distance
220-550m
550m/10km
100m
10km
1
30m@10Gbps
SFP-10G-T-X is not in supported in Cisco IOS XE Release 17.9.3.
SFP modules are not hot-swappable. When you plug and unplug the SFP module, a manual reload of the AP
is required.
8.
About Cisco Catalyst IW9167E Heavy Duty Access Point
Fiber/Cable Operating Temperature
Range
MMF IND
MMF/SMF IND
CAT 5e IND
SMF IND
CAT 6A/CAT 7 EXT
Supported External