Dometic NDS IM12-150 Installation And Operating Manual page 26

EN
4. Confirm or cancel the set setting.
The home screen appears.
Switch the house batteries on/off
1.
Tap the icon shortly.
The house settings are displayed.
2. Switch the house batteries off by tapping the
• The house batteries are disconnected.
• A sequence of beep sounds.
• The icon next to the corresponding setting lights up green.
• The house batteries are automatically switched on when a charging source is connected to the battery moni-
tor.
When the house batteries are switched off the batteries can be switched on via the display within 20 min. If the
20 min are over and the house batteries were not switched on via the control unit, the battery monitor switches off
(see Switching the battery monitor on/off
3. Confirm or cancel the set setting.
The home screen appears.
Setting the date and time
Tap on the date or the time to set the date and time.
Displaying brand information
Tap the
Displaying battery voltage and current
1. Tap on the battery symbol of the battery from which the technical values are to be displayed.
• If a house battery icon has been taped, the voltage and current of the house battery is displayed.
• If the starting battery icon has been taped, the voltage of the starting battery is displayed.
Note
• The data window closes automatically after 2 min.
• If all connected devices are switched off and the display shows a current above 0, calibrate the
battery monitor
2. Tap on the
Using the automatic mode
The automatic mode is activated automatically when the battery monitor is reconnected when too low voltage or too
high temperature of a battery is detected, or when the manual mode is deactivated.
Tap the icon to activate the automatic mode.
The icon changes to the
Using the manual mode
1.
Tap for 1.5 s the
A window for confirming and rejecting the activation of the manual mode appears.
26
on page 23).
icon to display the brand information.
(Calibrating
or icon to close the corresponding data window.
icon.
icon of the battery that shall be selected for operating.
icon next to corresponding setting.
on page 27).