Quick Get Start - Ebyte ECAN-W01S User Manual

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd

Manual

2. Quick Get Start

You need quasi ECAN-W01S * 1, power adapter * 1, network cable * 1, 2.4GWiFi antenna * 1,

CAN analyzer * 1;

1、 The factory default of the device is AP mode, the SSID is ECAN-W01S-XX, and the password is

12345678. After the device is powered on, search the device WiFi through the PC, as shown in

the following figure:

Click Connect to connect to the device's WiFi

2、 Open the network debugging assistant of the computer, set it as TCP Client, set the remote

host IP to 192.168.4.101, and set the remote host port number to 8881.

3、 Connect CAN1 of ECAN-W01S to CAN resolver. When ECAN-W01S is connected to CAN bus, just connect

CAN_ H connected to CAN_ H，CAN_ L connected to CAN_ L is enough. (Note that the default CAN

baud rate is 100K)

4、 The network assistant can be used to realize the communication between devices and peripherals.

Co.,Ltd

ECAN-W01S User

Table of Contents