Page 27
April 4, 2022
10.2 Create a report
The measurements can be extracted into a report. All additional
information from "Setting Window" is included in the report as well.
Fig. 10.2.1
10.3 Adding a New Sensor Scaling
The four inputs of the IDM Controller measure 0...10V which correspond
to the measurement range of the sensors. Hence each type of sensor
needs its scaling, which describes the relation between sensor distance
and voltage output.
The scaling of the sensors, which are included in the IDM Tool Kit, are
already defined in the software and can be selected as shown in the
picture below.
If a pressure sensor, flow meter or temperature probe is connected, just replace the unit [mm] to
[bar] or [°C] or any kind of unit.