Page 15
April 4, 2022
The computer screen will show a kiln tire with two rollers (top view).
To add more tires, click right mouse button and select "Add Pier" (see picture below)
See the green bar, which indicates the Sensor Distance (gap between roller surface and sensor).
It should be approximately in the middle of the sensor range, at least never go to one of the
extreme positions.
Software for Roller Shaft Bending Measurement:
Select the roller
to measure
Right Click to
add more
10
Sensor
Edit Sensor
Sensor
Input
Sampling
Distance
Settings
Type
Cannel
Frequency
7.4
Take Measurements
To start the measurement, select the roller on the computer screen and push the
Start button or [F5].
Fig. 7.4.1/2
After starting the measurement, the values will appear on the computer screen (green curve)