Take Measurements - TomTom Inductive Distance Measurement Tool Kit II User Manual

 Page 22
8.5

Take Measurements

To start the measurements push the Start button or [F5].
After starting the measurement, the values will appear on the computer screen (green curve)
Note:
To be able to calculate the run-out value and its position, the software needs a reference signal,
when the reference point is passing the sensors position.
Typically the manhole in the kiln or mill shell is used as reference point.
Each time when this reference point is passing the position of the sensors, push the button [F9] to
indicate the rotation. A yellow line in the graph will show the position of the reference point.
Measurement
Results
Switch to
Radar Chart
Radial Sensor
Signal (green)
Axial Sensor
Signal (blue)
Change X-Axis by
mouse right click
Hide / Unhide
curves
Reference Line
(when F9 was pushed)
April 4, 2022