Ip Variables; List Ip Settings (List Ip); Ip Address (Ip); Subnet Mask (Subnet) - Scanivalve DSA5000 Series Operation And Service Manual

DSA5000

IP Variables

The IP settings are used to control the static IP address, subnet, MAC address, and gateway for communications with the DSA
module. These variables can only be saved using the SAVE IP command, and changes do not take effect until a SAVE IP has
been completed, followed by a power cycle.

List IP Settings (LIST IP)

COMMAND
TYPE
DESCRIPTION
SYNTAX
RETURNS
EXAMPLE

IP Address (IP)

COMMAND
TYPE
DESCRIPTION
SYNTAX
RETURNS
DEFAULT
EXAMPLE
EXAMPLE

Subnet Mask (SUBNET)

COMMAND
TYPE
DESCRIPTION
LIST IP
Get
Returns all of the IP or bootloader settings
LIST IP
All of the settings, followed by the prompt.
LIST IP
IP 191.30.130.1
SUBNET 255.255.0.0
MAC 0:60:5d:82:0:04
GW 192.168.0.1
>
IP
Get/Set
Sets the IPv4 address of the DSA, or retrieves the current setting. A SAVE IP and REBOOT must be
performed for changes to take effect.
IP <nnn.nnn.nnn.nnn>
Where <nnn.nnn.nnn.nnn> is any valid IP address (each octet within 0 - 255).
IP <nnn.nnn.nnn.nnn>
- and/or -
Prompt when ready to accept a new command.
191.30.xxx.yyy
Where xxx is the model assignment:
130 = DSA5000
Where yyy is the last three digits of the serial number.
// Retrieve the current IP address of the DSA
IP
IP 191.30.130.2
>
// Set the IP address of the DSA
IP 192.168.0.1
>
SUBNET
Get/Set
Sets the IPv4 Subnet Mask of the DSA, or retrieves the current setting. A SAVE and REBOOT must
be performed for changes to take effect.
57
57
Section 5: Software