Udp Variables; List Udp Settings (List Udp); Udp Output Control (Udp); Udp Output Destination (Ipudp) - Scanivalve DSA5000 Series Operation And Service Manual

Section 5: Software

UDP Variables

The UDP settings control the target and enable the transfer of scan data out using UDP protocol.

List UDP Settings (LIST UDP)

COMMAND
TYPE
DESCRIPTION
SYNTAX
RETURNS
EXAMPLE

UDP Output Control (UDP)

COMMAND
TYPE
DESCRIPTION
SYNTAX
RETURNS
DEFAULT
EXAMPLE
EXAMPLE

UDP Output Destination (IPUDP)

COMMAND
TYPE
DESCRIPTION
SYNTAX
RETURNS
DEFAULT
LIST UDP
Get
Returns all of the UDP settings
LIST UDP
All of the settings, followed by the prompt.
LIST UDP
ENUDP 0
IPUDP 224.0.1.2 7000
>
ENUDP
Get/Set
Enables or disables UDP data output by the DSA, or retrieves the current setting.
ENUDP <status>
Where <status>:
0 = UDP output is disabled
1 = UDP output is enabled. Scan data format is binary.
ENUDP <status>
- and/or -
Prompt when ready to accept a new command.
0
// Enable UDP output
ENUDP 1
>
// To find the current setting
ENUDP
ENUDP 0
>
IPUDP
Get/Set
Configure the data destination for UDP output by the DSA, or retrieves the current setting.
IPUDP <ip address> <port>
Where <ip address> is any valid IPv4 address, including multicast addresses.
Where <port> is the UDP port from 1 to 65535.
IPUDP <ip address> <port>
- and/or -
Prompt when ready to accept a new command.
0.0.0.0 0
52
52
DSA5000