Table of Contents
Advertisement
DJ24
DJ24 REAR PANEL DIAGRAM
1
REAR PANEL: INPUTS AND OUTPUTS
1. AC Cord. See safety precautions on page 3 for
proper treatment of the power cord.
2. GND is the grounding lug for turntables 1 and 2
(phono inputs on Channels 1 and 2). Always use this
connection (your turntable cable should have a
grounding wire).
3. The Stereo Main Outputs are low-impedance
RCA connectors controlled by the Master fader.
4. The Stereo Zone Outputs are low-impedance
unbalanced RCA jacks controlled by the Zone Level
control.
5. The Tape Outputs are low-impedance
unbalanced RCA jacks which output the program mix
and allow you to connect any recording device.
6. Mic 2 is a high-impedance 1/4" input.
©1998 Numark Industries
4
5
3
Numark - The Proven Leader in DJ Technology
...
7
7
7
7. Channels 1-3 Line Inputs are unbalanced RCA
jacks. The Line Input is selected with the toggle
switch on the front panel.
You can connect stereo audio from HiFi VCRs, cassette
and reel-to-reel tape decks, DAT machines, CD players,
laser discs, tuners, even synthesizers or other mixing
consoles.
N O T E : Plug mono audio sources into both Left and
Right inputs using a "Y" cable connector.
8. Phono Inputs on Channels 1 and 2 use
unbalanced RCA jacks. Your input signal is fed directly
to the D J 2 4's high-quality RIAA phono pre-amplifiers
so use this position only for moving magnet cartridges.
Line level sources will overload the sensitive phono
pre-amps and will sound very bad, so always be sure to
toggle the line/phono switch over to line before
connection of line sources.
12
6
8
7
8
http://www.numark.com
2
Advertisement
Table of Contents
