Numark DM1295 Owner's Manual

Numark DM1295 Owner's Manual

Professional dj sampling mixer

Advertisement

©2000
Professional Disc Jockey Products
DM1295
DM1295
DM1295
DM1295
PROFESSIONAL DJ SAMPLING MIXER
PROFESSIONAL DJ SAMPLING MIXER
PROFESSIONAL DJ SAMPLING MIXER
PROFESSIONAL DJ SAMPLING MIXER
Owner's Manual
Industries
http://www.numark.com

Advertisement

Table of Contents
loading

Summary of Contents for Numark DM1295

  • Page 1 Professional Disc Jockey Products PROFESSIONAL DJ SAMPLING MIXER PROFESSIONAL DJ SAMPLING MIXER PROFESSIONAL DJ SAMPLING MIXER PROFESSIONAL DJ SAMPLING MIXER Owner’s Manual ©2000 Industries DM1295 DM1295 DM1295 DM1295 http://www.numark.com...
  • Page 2: Safety Instructions

    DM1295 Safety Information SAFETY INSTRUCTIONS a) Read Instructions - All the safety and operating instructions should be read before this product is connected and used. b) Retain Instructions - The safety and operating instructions should be kept for future reference.
  • Page 3 DJ market and the professional installation market. The DM1295 provides the end user with high-end audio circuitry combined with maximum versatility to meet the demands of every intended situation. This mixer features 8 line, 3 phono, and 2 microphone inputs, balanced XLR outputs, and a built in sampler with 110 seconds of memory storage and polyphonic playback.
  • Page 4: Mixer Features

    DM1295 MIXER FEATURES INPUTS Input Toggle Switches - select which source will be live to that channel based on what you have connected to the rear panel input section. Input faders - control individual source levels in the mix. Note: Never use spray cleaners on the slide controls. Residues cause excessive dirt build-up and this will void your warranty.
  • Page 5: Equalizer Section

    20. Headphone Jack – to plug in your ¼” headphones. 21. Power Switch – turns unit on and off. 22. BNC Connector – for a 12V gooseneck light to be attached. - The Leader in DJ Technology - 5 - DM1295 HEADPHONE CUEING http://www.numark.com...
  • Page 6 DM1295 - The Leader in DJ Technology ©2000 Industries - 6 - http://www.numark.com...
  • Page 7: Sampler Operation

    While a sample is playing as a loop other samples can be played back as well as single play. One single play sample and one loop can be played at the same time creating some very interesting effects. ©2000 Industries - The Leader in DJ Technology - 7 - DM1295 http://www.numark.com...
  • Page 8: Rear Panel Features

    DM1295 REAR PANEL FEATURES Power Connector. Plug in power cord here and check the voltage level to match your country’s standard. GND is the grounding lug for turntables 1, 2 and 3 (phono inputs on Channels 1, 2 and 3). Always use this connection (your turntable cable should have a grounding wire).
  • Page 9: Quick Setup Diagram

    IMPORTANT: Always switch on your audio input sources such as turntables or CD players first, then your mixer, and finally any amplifiers. When turning off, always reverse this operation by turning off amplifiers, then your mixer, and then input devices. ©2000 Industries - The Leader in DJ Technology - 9 - DM1295 http://www.numark.com...
  • Page 10: Specifications

    DM1295 SPECIFICATIONS INPUTS: Line: Mic: Phono: OUTPUTS: Line: Headphone Amp: 1V rms watt into 16ohm Distortion: SIGNAL TO NOISE RATIOS* (vs. maximum output): Line: Mic: Phono: FREQUENCY RESPONSE: Line: Line: Phono: EQUALIZER: 6-Band Stereo Graphic EQ Band centers 42 Hz, 152 Hz, 480Hz, 1.52KHz, 4.8KHz, 15.36KHz +/- 15 dB SAMPLER: Sampling length: 110 Seconds, 27.5 seconds per bank...
  • Page 11: Block Diagram

    DM1295 BLOCK DIAGRAM - The Leader in DJ Technology ©2000 Industries - 11 - http://www.numark.com...
  • Page 12: Limited Product Warranty

    What is covered and for how long? NUMARK INDUSTRIES LCC ("NUMARK") warrants to the original purchaser that NUMARK products; including but not limited to DJ mixers, amplifiers, CD players, CD Mix Stations, turntables, preamplifiers, beatkeepers, equalizers, microphones, headphones, cartridges, and all other accessories; are to be free from defects in material and workmanship under normal use and service for the period commencing upon the date of purchase from an authorized NUMARK dealer for a period of (1) Year.

Table of Contents