Problems, Causes And Solutions - Mr. Coffee BVMC-ECM-PMPAT Series User Manual

tube, or let the cycle run until it stops automatically.
7. Repeat Steps 1 – 6 as necessary using only tap water to rinse any remaining
traces of vinegar out of the machine.
CLEANING NOTIFICATION
After 200 cycles the Cleaning Notification will activate.
1. The Cleaning Indicator Light will remain on as a notification until the cleaning
procedure is completed.
a. If you brew another espresso. latte. or cappuccino. the cleaning light
will turn off momentarily, but will start flashing after completion of the
brew.
b. When the unit is powered off the Cleaning Indicator Light will turn off.
c. When the unit powers down and goes into sleep mode, the cleaning
indicator light will turn off.
CLEANING PROCEDURE
1. Pour a solution of 50% white vinegar and 50% clean water into the water tank.
Stir the solution with a spoon to make sure it is properly mixed.
2. Rotate the milk tank knob to the clean position. Place a large cup under the
frothed milk dispensing tube.
3. Press the clean button for 5 seconds to activate the deep clean mode.
a. The progress bar slowly cycles, same as when the brew cycle is
operating, through the entire cleaning cycle.
b. The pump will turn on and off multiple times for about 7.5 minutes.
The cleaning light will then turn off indicating that the cleaning cycle is
completed.
4. Pour out any remaining solution from the water tank and replace with clean
water. Fill with clean water up to the Max level line.
5. Press the manual Espresso button "
the manual espresso button to stop the machine.
6. Rotate the milk tank knob to the clean position and press the clean button to
run the normal clean mode.
7. Press the espresso button and then the steam function to flush the system out.
20
BVMC-ECM-PMPAT_22ESM2 (US).indd 20-21 BVMC-ECM-PMPAT_22ESM2 (US).indd 20-21
" and let the water fill a cup, then press

PROBLEMS, CAUSES AND SOLUTIONS

PROBLEM CAUSES
Coffee does not • No water in reservoir.
come out. • Coffee grind is too fine.
• Too much coffee in the filter.
• Appliance was not turned on
or plugged in.
• Coffee has been tamped/
compressed too much.
Coffee comes out • Porta-filter not rotated to full
around the edge of lock position.
the porta-filter. • Coffee grounds around the
filter basket rim.
• Too much coffee in the filter.
Milk is not foamy • Check the froth control
after frothing or it is position.
not coming out of • Ran out of steam.
the frothing tube. • Milk is not cold enough.
• Frothing tube is blocked.
Coffee comes out • Ground coffee is too coarse.
too quickly. • Not enough coffee in filter.
Coffee is too weak. • Using single filter for double
shot of espresso.
• Ground coffee is too coarse.
The control panel • Water reservoir is out of
lights are flashing. water.
• Brewing function button was
pressed prior to the progress
bar fully illuminating to show
the machine is ready.
Cleaning light • Your machine is letting
remains on. you know it is ready for
a cleaning cycle to be
performed.
SOLUTIONS
• Add water.
• Grind medium ground
coffee.
• Fill filter with less coffee.
• Plug unit into electrical
outlet and turn it on.
• Refill filter basket with
coffee and TAMP GENTLY.
• Rotate filter holder to full
lock position.
• Wipe off rim.
• Fill with less coffee.
• Ensure there is enough
water in the water reservoir.
• Chill milk prior to making
cappuccino or latte.
• Follow the instructions to
clean the milk reservoir &
frothing tube.
• Use a finer grind.
• Fill filter with more coffee.
• Use double filter for double
shot of espresso.
• Use a finer grind.
• Add water to reservoir.
• Wait until the progress bar
is fully illuminated, and a
solid light, to indicate the
machine is ready.
• Perform cleaning cycle (see
page 20).
21
2022/4/8 9:31 AM 2022/4/8 9:31 AM