Problems And Causes - Mr. Coffee ECM10 Instruction Manual With Recipes

P
ROBLEM
Coffee does • No water in reservoir
not come out
• Coffee grind is too fine
• Too much coffee in the filter
• cap is not secure, steam is escaping
• Appliance was not turned on
• Coffee has been tamped /
Coffee comes • Filter holder not rotated
out around
the edge of the
• Coffee grounds around the filter
filter holder
• Too much coffee in the filter basket
• Water reservoir is empty
No steam is
generated
• Too much water in the reservoir –
• Appliance is not turned on
• Frothing tube is blocked
Milk is not
• Ran out of steam
foamy after
frothing
• Milk is not cold enough
Coffee comes
• Ground coffee is too coarse
out too quickly
• Not enough coffee in filter basket
Coffee is
• Water tank is empty or low,
splattering out
of frothing tube
P
R O B LE M S A N D
C
AUSES
or plugged in
compressed
to full lock position
basket rim
no room for steam
not enough pressure
C
A U S E S
• Add water
• Grind coffee medium ground
• Fill filter only to 4 Cup mark
• Tighten cap
• Plug unit into electrical outlet.
Turn on
• Refill filter basket with coffee.
DO NOT TAMP
• Rotate filter holder to full lock
• Wipe off rim; fill only to 4 Cup
mark
• Fill only to 4 Cup mark
• Fill reservoir with correct amount
of water. See Page 6
• Empty some water from reservoir.
See Page 6
• Turn on unit with control knob
• Following frothing stage, operate
frothing function for 1 – 2 seconds
to extract excess milk. Or, turn off
unit, allow unit to cool, unplug unit
and clean out frothing tube with
a needle.
• Pour in the required amount
of water to make cappuccino.
See Page 6
• Chill milk and frothing pitcher
prior to making cappuccino
• Use a finer grind
• Use more coffee
• Once unit has cooled, use more
water to brew espresso
11
S
OLUTIONS