Installing The Module - Northland 18AF-SB Installation, Operation And Maintenance Instructions

Built-in refrigerator/freezer

Hide thumbs

Table Of Contents

Table of Contents

Rear Shoulder Screw

Front

Shoulder

Screw

Place module on top of the cabinet with rear shoulder screws resting on the locator brackets behind the front slots.

Slide module toward the rear of the cabinet until the rear shoulder screws engage the slots in the rear of the brack-

ets. Rest the front shoulder screws into the front slots of the brackets.

IMPORTANT

Check to make sure wiring and ice maker tubing is clear and not interfering with module seal. Do NOT start prod-

uct during construction, as dust can block module condenser coils. If dust accumulates on coils, vacuum immedi-

ately, using a soft brush attachment.

Do NOT operate the refrigerator in the presence of explosive fumes.

Do NOT install the refrigerator where the temperature will drop below 60 degrees F (15 degrees C) or rise above

110 degrees F (43 degrees C). The compressor will NOT be able to maintain proper temperatures.

Make electrical connections from the top

of the lower cabinet to the junction box

at left side of module. If NO ice maker

then only one cabinet line will be pro-

tuding. With ice maker, be sure to plug

the ice maker line into the module, and

the solenoid valve as well. See module

diagram on the right.

Module NOT fastened to cabinet below. Remove

before tipping or transporting.

Ice Maker

Leads