Installing The Side Panels And Kick Plate - Northland 18AF-SB Installation, Operation And Maintenance Instructions

INSTALLING THE SIDE PANELS AND KICK PLATE

Instructions for Fastening Side Panels to
Refrigerator
1. Side panels should be 24 inches D (or 24
5/16 inches D when tucked into the front
trim).
2. Panel height to match installation height.
3. Install the side panels per drawings on the
right.
NOTE: To avoid damage to panels or floor-
ing, raise panels slightly, to clear floor when
installing.
Drill three (3) holes equal distance apart in
vertical section of aluminum frame and install
pan head screws as shown.
Anchor side panel with screw as shown. Be
sure screw used goes no more than 1/2 inch
deep into product. Do NOT overtighten.
Use two (2) #8 sheet metal screws to facilitate holding your kick plate in place. Mount screws in holes in roller
base. Notching of upper corners may be required to clear hinges.
12
Kick Plate Installation
#8 Sheet
Metal Screw
Typical Side Panel Installations
Typ.
1 1/8"
"A"
3/16" Thick Back Up
"B"
1/8" Thick Back Up
"C"
2 3/16"
"D"
Drill three (3) holes equal distance apart in vertical section of aluminum frame and install # 6 - 3/8 pan head
screws as shown (provided).
Attach side panel to cabinet with screws as shown. Screws must not penetrate cabinet more than 1/2 inch.
Measure the distance between
mounting holes on roller base.
1/4" Thick Battens
1/4" Plywood/Panel
3/16" Thick Battens
1/4" Plywood/Panel
24 5/16"
1/16" Rout
1/2" Plywood/Panel
11/32"
Metal Side Panel
(Typ. Installation Opening)
24"
5/16"