Corner Installation And Installing Two Units Side By Side - Northland 18AF-SB Installation, Operation And Maintenance Instructions

CORNER INSTALLATION AND INSTALLING TWO UNITS SIDE-BY-SIDE
7/8"
4
1" or
3" Min.
Filler
Cabinet Outline
Enclosure must permit refrigerator to be removed
for service.
PANEL READY UNITS: For corner installations, a
minimum one (1) inch filler must be used as shown
above.
ANY UNIT WITH FACE MOUNTED HANDLE: Filler
must be three (3) inches minimum.
Installing Two Units Side-By-Side
When two (2) units are installed together, a 23 1/2
inch x 12 inch (minimum) divider panel needs to be
installed between the two (2) modules (refer to Illustra-
tion) with self-tapping screws. The divider panel can
be made of any material available, (i.e. 1/32 inch
aluminum, 1/8 - 1/4 inch wood paneling), or you can
order Kit # 34747-000 from the Northland Service
Department. Locate the divider panel approximately
one (1) inch down from the top of the cabinet and
flush with the back of the cabinet. Drill three (3) pilot
holes approximately 1/2 inch up from the bottom of
divider panel, through panel, and into cabinet. Secure
the panel to the cabinet with three (3) screws using
pilot holes previously drilled.
Drill three (3) holes each side
equal distance apart in vertical
section of aluminum frame and
install screws as shown.
Wood Shim
7/8" x 1" x 68"
1"
A
• Install wood shim to one of the
cabinets before installing cut-
out cavity (not provided).
• After properly installing both
cabinets, drill trim and install
pan head screws (provided).