Installation - Northland 18AF-SB Installation, Operation And Maintenance Instructions

Select Location
Locate the refrigerator/freezer in the coolest part of the
room, out of direct sunlight and away from heating
ducts or registers.
Do not place the refrigerator/freezer next to heat-
producing appliances such as a range, oven or dish-
washer. If this is not possible, a section of cabinetry
or an added layer of insulation between the two (2)
appliances will help the refrigerator/freezer operate
more efficiently.
IMPORTANT
When installing the water line for the ice maker, be
sure to install a SHUT-OFF VALVE at a convenient loca-
tion between the refrigerator and the supply line.
Required water pressure range is 20 to 120 psi.
Also required is an in-line WATER FILTER between the
refrigerator and the supply line to prevent sediment
from blocking water flow through the water solenoid
valve.
NOTE: Self-piercing water valves and plastic tubing
are NOT approved for water supply to ice maker.
Electrical Connection
The module comes with a 3-prong power suppply
cord. It must be plugged into a mating 115 volt, 60
Hz, 15 amp separately fused, 3-prong grounded
outlet serving only this product, and wired in accor-
dance with National and Local Electrical Codes and
ordinances. A time delay fuse or circuit breaker is
recommended. DO NOT USE AN EXTENSION CORD
OR ADAPTER PLUG.
DO NOT REMOVE THE GROUND PRONG FROM
THE POWER SUPPLY CORD UNDER ANY CIRCUM-
STANCES!
If voltage varies by 10 percent or more, performance
of your refrigerator/freezer may be affected. Operat-
ing the refrigerator/freezer with insufficient voltage can
damage the compressor. Such damage is not covered
under your warranty. If you suspect your voltage is
high or low, consult your power company for testing.
Do NOT pinch, knot, or bend the power cord in any
manner.
NEVER unplug the refrigerator/freezer by pulling on
the power cord. Always grip the plug firmly and pull
straight out from the receptacle. To avoid electrical
shock, unplug the refrigerator/freezer before cleaning
and before replacing a light bulb.
NOTE: Turning the control to "OFF" turns off the
compressor, but does not disconnect power to the light
bulb or other electrical components. The unit MUST
be unplugged or turned off at the circuit breaker.

INSTALLATION

3