NorthStar 1201 Owner's Manual page 38

images together. It cannot display a primary image with an
auxiliary image. The illustration below summarizes this:
AUX
VIDEO
VIDEO
DATA
The two examples on the left will work. The two on the right
will not.
Miscellaneous Wiring
IR Repeater
If you wish to control audio/video devices remotely, you can
plug an infrared transmitter into the vBox (RJ45) connector
marked IR REPEATER. Terminate the IR repeater with a
male RJ-45 connector as shown in the table below.
IR Repeater
RJ-45 Pin Number
Place the IR transmitter adjacent to the infrared receiver on
the device to be controlled.
Signal Redrive
The vBox will redrive the primary data and video signals that
it receives. If you wish to extend the cable length of these
signals, connect to the redrive outputs on the vBox. These
are marked VIDEO OUT and DATA OUT. The redriven signals
can be run a maximum of 50 feet.
Page 34 — Optional vBox
VIDEO
AUX A AUX
DATA DAT DATA
IR Signal
7 IR +
8 IR –
1200 Series Display, Rev. A2
AUX
VIDEO
DAT DATA