Table of Contents
Advertisement
Connecting the vBox to Video Sources
Run cables (see diagram on page 32) from video sources such
as VCRs, DVDs, cameras, etc. to the vBox. These cables must
be terminated with BNC male connectors.
Plug the primary video signal into the vBox BNC connector
marked VIDEO. Connect the auxiliary video source to the
AUX VIDEO input on the vBox. Make sure that all connec-
tors have been secured and that the general guidelines
outlined on page 23 have been observed.
If crimp connections were made, verify that the proper tools
were used and that the crimps are making positive mechan-
ical and electrical connection.
When configuring a display with a vBox, it is best to connect
all four inputs. The examples below illustrate how to do this.
NOTE:
!
1200 Series Display, Rev. A2
In order to use the vBox, you must
have at least one connection to the
primary ports (DATA and VIDEO) and
one connection to the auxiliary ports
(AUX DATA and AUX VIDEO)
Optional vBox — Page 31
Advertisement
Table of Contents
