Installing The Device - Siemens SIMATIC NET RUGGEDCOM RSG2100 Installation Manual

Installing the Device

This chapter describes how to install the device, including mounting the device,
connecting power, and connecting the device to the network.
Electrocution hazard – risk of serious personal injury and/or damage to
equipment.
Before performing any maintenance tasks, make sure all power to the device has
been disconnected and wait approximately two minutes for any remaining energy
to dissipate.
Do not disconnect or open equipment unless power has been switched off or the
area is known to be non-hazardous.
Radiation hazard – risk of serious personal injury
This product contains a laser system and is classified as a CLASS 1 LASER PRODUCT.
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
Burn hazard – risk of personal injury
The surface of the device may be hot during operation, or as a result of the ambient
air temperature.
Wear appropriate personal protective equipment and use caution when working
with or around the device.
This product contains no user-serviceable parts. Attempted service by unauthorized
personnel shall render all warranties null and void.
Changes or modifications not expressly approved by Siemens Canada Ltd. could
invalidate specifications, test results, and agency approvals, and void the user's
authority to operate the equipment.
RUGGEDCOM RSG2100
Installation Manual, 11/2022, C79000-G8976-1040-20
DANGER
WARNING
WARNING
CAUTION
NOTICE
2
7