Advertisement
4. Service menu
4.3.4. Power settings
See Figure 28. This menu has the following 2 options:
Standby mode
There are three available choices — use the minus and
plus buttons to select the various functions.
MNU = With this setting you access the operator
menu via the enter button (8). Select the required
setting.
IMM = Immediate standby
2S = Standby after a delay of 2 seconds
Standby, camera off
If this option is enabled, the camera power is off during standby.
4.3.5. CAN bus
See Figure 29. This option opens the CAN bus menu. This menu has
the following 4 options:
CAN protocol
This option selects the signal, or CAN protocol, that the display
uses. By default this is Orlaco CAN protocol 1. For the Orlaco Radar
system, Orlaco CAN protocol 6 must be set. Other protocols are
customer-specific. The CAN speed is automatically adjusted, but it
can also be set manually once the protocol has been selected.
CAN speed
This option selects the bit rate of the CAN bus. Available options
are: 100, 125, 200, 250, 500 and 1000 kbit.
Main terminator
Enable/disable the 120 Ω terminator (CAN or RS485) between Rx
and Tx.
AUX terminator
Enable/disable the 120 Ω terminator (CAN or RS485) between
AUX1 and AUX2.
4.3.6. LCD backlight
This option opens the backlight submenu for the 7" RLED/LEDD
display. See Figure 30. This menu has the following 4 options:
LCD backlight mode
This option enables automatic backlight control (ABC). The
display automatically adapts its brightness to the ambient light.
Metering sensor on the keyboard. If required, a specific day or
night brightness can be manually set.
ABC minimum level
This setting determines the minimum brightness the ABC can use
when there is low ambient light.
LCD backlight day
This option allows the day brightness setting to be manually
adjusted (50–100%).
LCD backlight night
This option allows the night brightness setting to be manually
adjusted (0–50%).
14
Figure 28
Figure 29
Figure 30
UM0972011 A 01
Advertisement
