Advertisement
4. Service menu
4. Using the service menu
To open the service menu, simultaneously press the camera selection
button (1), the minus button (6) and the plus button (7) (see Figure
13). The display (see Figure 14) will appear. The following buttons are
used to navigate through the menus:
5 - Option/previous menu: Return to the previous menu
6 - Minus: Go to the next menu option
7 - Plus: Go to the previous menu option
8 - Enter: Select or enable the chosen option
4.1. Camera settings
Select camera settings. Press enter to open the 'Camera settings' menu.
Use the minus (6) and plus (7) buttons to select which camera to configure.
Then confirm this selection by pressing the enter button (8). The yellow
cursor is now activated in the list of items. Use the minus (6) and plus
(7) buttons to select the item to adjust and then confirm this selection by
pressing the enter button. If the selection is an on/off switch, you can choose
between on and off. If the selection is a number, you can change the value
using the minus (6) and plus (7) buttons. Save the new settings by pressing
the enter button (8).
4.1.1. Mirror
Enable this option to reverse the image (left/right).
4.1.2. Upside down
This option flips the image (upside down).
4.1.3. Switch delay
Enable this option if the switchwire is controlled by an intermittent
signal (e.g. from an indicator light).
4.1.4. Horizontal line mark
Enable this option to show a reference line. The reference line is
displayed as a horizontal green line. See Figure 40 on page 17.
4.1.5. Line position
Adjusts the vertical height of the reference line. 0 corresponds to the
top edge of the monitor and 100 to the bottom edge.
4.1.6. Vertical line mark
Enable this option to show a reference line. The reference line is
displayed as a vertical green line. This option is not available on all
RLED/LEDD models. See Figure 40 on page 17.
4.1.7. Line position
Adjusts the vertical position of the reference line. This can be set
between 38 and 63. The left and right sides swap position depending
on the settings of the camera mirror-image function.
4.1.8. Graticule
This option shows a graticule for a rearview camera on the monitor.
See Figure 40 on page 17.
10
1
Button
5
Button
objects in
C3
monitor are
C2
closer than
C1
they appear
Buttons 1
2 3 4 5 6 7 8
Buttons
Button
Buttons
Button
Figure 13
Buttons
Figure 14
Figure 15
Figure 16
6 + 7
1
6 + 7
1
2
Button
5,6,7,8
Button
UM0972011 A 01
3
Advertisement
