KRAUSE & BECKER 62915 Owner's Manual & Safety Instructions page 12

if Sprayer is not properly cleaned immediately after every use.
Clean Sprayer immediately to prevent permanent damage.
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under subheadings therein
before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Priming Spray Gun
This procedure is used for first time operation and also to flush storage fluids out of the Sprayer.
For Oil-based Paint:
Flush with mineral spirits followed by warm, clean water.
WARNING! TO PREVENT FIRE:
When using mineral spirits, ground gun by holding
it against a metal container while flushing.
1. Separate smaller Priming Tube from Suction Tube.
2. Place Priming Tube in waste bucket.
3. Submerge Suction Tube in water or flushing solvent.
Page 12
RETURNS NOT ACCEPTED & WARRANTY VOID
For technical questions, please call 1-888-866-5797.
For Water-based (Latex) Paint:
Flush with warm, clean water.
4. Turn Prime/Spray switch to Prime mode.
Hi Spray Low Spray Prime/Clean
5. Adjust Pressure Control Knob to Prime/Clean setting.
6. Plug in Sprayer and turn power ON.
Roll
ON
Item 62915