Backyard Creations 272-1799 Manual

Hammock chair stand

LOOSELY TIGHTEN ALL BOLTS DURING ASSEMBLY. IF YOU

OVERTIGHTEN THE BOLTS DURING ASSEMBLY IT WILL BE

DIFFICULT TO LINE UP PARTS CORRECTLY.

AT THE END OF ASSEMBLY, ONCE ALL PARTS ARE

ASSEMBLED, MAKE SURE YOU GO BACK AND

INDIVIDUALLY TIGHTEN EACH PIECE OF HARDWARE. NOT

TIGHTENING HARDWARE COULD CAUSE THE FRAME TO

DISASSEMBLE.

AFTER TIGHTENING EACH PIECE OF HARDWARE MAKE

SURE TO DOUBLE CHECK ALL HARDWARE IS FULLY

TIGHTENED.

Menard SKU#:272-1799

Item No:905433

Item UPC Code：6-8119-05433-6

Page

Table of Contents

Need help?

Do you have a question about the 272-1799 and is the answer not in the manual?

Page 1 ASSEMBLED, MAKE SURE YOU GO BACK AND INDIVIDUALLY TIGHTEN EACH PIECE OF HARDWARE. NOT TIGHTENING HARDWARE COULD CAUSE THE FRAME TO DISASSEMBLE. AFTER TIGHTENING EACH PIECE OF HARDWARE MAKE SURE TO DOUBLE CHECK ALL HARDWARE IS FULLY TIGHTENED. Menard SKU#:272-1799 Item No:905433 Item UPC Code：6-8119-05433-6 Page...
Page 2 Part List (Weight Capacity:250LBS) X2PCS A1+A2 Page2...
Page 3 Step1 Step2 Page3...
Page 4 1:This Chair Stand is not built One Person Only In Chair at a for Swinging. Time 2：Secure all hardware tightly. Maximum Weight: 250 lbs. 3：Hardware should be checked once a month to ensure it is tightened Step3 Step4 1：Hole in footplates are for securing the frame to the ground 2:Hanging Chair Stand...
Page 5 WARNING Frames: Damage to frame or welds due to commercial use, improper assembly, exposure to freezing water and temperatures or using the frame as a swing will not be covered as a defective product. Metal Finishes and /Or paint : Fading resulting from exposure to elements, chemicals,and spills are not covered.
Page 6 6-8119-05433-6 page 6...

905433