MCS software deployment
Use the procedures in this section to deploy the MCS 4.0 software.
Overview
Each of the following sections describes a required procedure.
The procedures must be performed in the order given.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
During MCS software installation, the following are configured automatically
(you only need to deploy and run them):
•
•
•
•
•
Copyright © 2007, Nortel Networks
.
"Launch the Management Console" (page 46)
"Update the license key" (page 46)
"Start the Server Monitor" (page 54)
"Start the Database Monitor" (page 54)
"Deploy and start network elements" (page 47)
"Install MCS online Help" (page 49)
"Install the Wireless Client Manager" (page 50)
"Add the WiCM server IP address" (page 52)
"Add the WiCM server" (page 53)
"Start the Server Monitor" (page 54)
"Start the Database Monitor" (page 54)
Accounting Manager
Session Manager
Provisioning Manager
IP Client Manager (if required)
UFTP base software (if IPCM is required)
Nortel Multimedia Communication Server 5100
MCS Installation and Commissioning
NN42020-308 01.08 Standard
Release 4.0 13 September 2007
ATTENTION
45