CLI Conventions
You should be aware of the following WLE2340 Software CLI conventions for command entry:
•
"Command prompts" on page 13
•
"Syntax Notation" on page 13
Command prompts
By default, the WLE CLI provides the following prompt. For ease of presentation, this manual shows the enabled
prompts as follows:
WLE>
WLE#
For information about changing the CLI prompt on a WLE, see set prompt.
Syntax Notation
The WLE2340 Software CLI uses standard syntax notation:
•
Bold monospace font identifies the command and keywords you must type. For example:
set enable
Syntax
•
A vertical bar (|) separates mutually exclusive options within a list of possibilities. For example, you enter either
enable or disable, not both, in the following command:
set ssh {enable | disable}
Syntax
Nortel WLAN — Location Engine 2340 Using the Command Line Interface
Using the Command-Line Interface 13