Advertisement
Other Useful Information (Cont.)
Spray arms
Make sure that the spray
holes are not clogged
and that no food waste or
foreign objects are stuck
to the spray arms (Fig. 25).
If there is any clogging,
remove the spray arms and
clean them under running
water.
To remove the upper spray
arm, undo the nut holding
it in position by turning it
clockwise and pulling it
downwards. Make sure that
the nut is properly tightened
when refitting the upper
spray arm.
Risk of cuts! When cleaning the waste water pump, ensure that you do not injure
yourself on pieces of broken glass or pointed implements.
Drain pump
Large amounts of food residue, or any foreign objects not captured by the filters may
block the waste water pump. The rinsing water will then be above the filter. Please
clean/maintain the drain pump regularly to avoid this.
•
Before cleaning the drain pump, always disconnect the appliance from the power
supply.
•
Take out the baskets, and remove the filters (see page 32).
•
Scoop out any water, using a sponge if required.
•
Check the drain pump area, and remove any foreign objects or food residue.
•
Re-install the filters.
•
Re-insert the baskets.
Cleaning the exterior of the appliance
Clean the door seals regularly with a soft damp cloth to remove food deposits.
When the dishwasher is being loaded, food and drink residues may drip onto the sides
of the dishwasher door. These surfaces are outside the wash cabinet and are not
accessed by water from the spray arms. It is therefore important that you wipe off any
deposits before you close the door.
If the control panel is dirty, wipe it with a soft, damp cloth only and dry thoroughly.
(AU) 1300 886 649 (NZ) 0800 836 761 |
Fig. 25
WARNING!
After Sales Support
tempo.org/support
33
33
Hide quick links:
Advertisement
