Advertisement
Installation (Cont.)
Water connection
• We recommend fitting a filter to your water inlet supply in order to prevent damage to
your machine due to contamination (sand, rust, etc.) from indoor plumbing. This will
also help prevent yellowing and deposit formation after washing.
• Only onnect the water inlet hose to a cold water supply.
•
WARNING!
Always close the water tap after using the dishwasher.
Water inlet hose:
• Screw the hose to an appropriate faucet with a cold water supply (Fig. 4).
•
WARNING!
Use the new water inlet hose supplied with your machine, do not use an
old machine's hose.
•
WARNING!
Run water through the new hose before connecting it.
WARNING!
•
Connect the hose directly to the
water inlet tap. The pressure supplied by the
tap should be a minimum of 0.03 MPa and a
maximum of 1 MPa. If the pressure exceeds
1 MPa, a pressure relief valve must be fitted
between the connection.
WARNING!
•
After the connections are made,
turn the tap on fully and check for water leaks.
Always turn off the water inlet tap after a wash
program has finished.
• An Aquastop inlet hose has components that
use 240 V. Do not damage it or allow it to
become kinked or twisted.
(AU) 1300 886 649 (NZ) 0800 836 761 |
Drain hose connection
Fig. 5
• The drain hose must be connected to
the drain hose connector at the back
of the dishwasher. Insert the drain
hose into a drain pipe with a minimum
diameter of 40 mm, or let it run into the
sink, making sure to avoid bending,
crimping or squashing it. The height
of drain pipe must be greater than 500
mm and less than 1100 mm from the
floor (Fig. 5). The free end of the hose
must not be immersed in water to avoid
the backflow of water.
After Sales Support
Fig. 4
tempo.org/support
11
11
Hide quick links:
Advertisement
