Advertisement
Installation (Cont.)
Levelling the appliance
• Position the dishwasher on a level and sturdy
floor.
• If the floor is uneven, adjust the adjustable feet
until it reaches a horizontal position; just screw
the feet in or out a little (Fig. 1).
• The appliance should not be inclined more than
2°.
• Correctly levelled, the appliance will be more
stable and much less likely to move or cause
vibrations and noise during operation.
Freestanding installation
Between existing cabinets
• The height of the dishwasher, 850 mm, has
been designed in order to allow the machine to
be fitted between existing cabinets of the same
height in modern fitted kitchens (Fig. 2).
• The feet can be adjusted so that the correct
height is reached.
Underneath an existing worktop
• If you wish to fit the machine under
an existing countertop, there must be
sufficient space to do so (see
Fig. 3, 1). The installation space must
match these outlined dimensions.
• WARNING:
must be stable, in order to prevent
imbalance.
• If the space under the countertop is
suitable for installing your machine,
remove dishwasher's built-in worktop/
top panel first.
• To do so, first remove the screws
holding it in place, located at the rear
of the machine. Then, push the panel
1 cm from the front towards the rear
and lift it (Fig. 3, 2).
• Adjust the machine feet to account for
the slope of the floor (Fig. 3, 3).
• Push the machine under the counter, taking care not to crush or bend the hoses (Fig 3, 4).
10 10
(AU) 1300 886 649 (NZ) 0800 836 761 |
The existing countertop
After Sales Support
Fig. 1
Fig. 2
Fig. 3
H1: min A
H2: min B1
H3: min B2
tempo.org/support
Hide quick links:
Advertisement
