Figure 2 Rear Panel Of The Instant Internet 100 Unit - Nortel BayStack 100 Setting Up

30 Chapter 3 Instant Internet 100 hardware installation
On the rear panel of the unit (from left to right) are switches and connectors as
follows:
• At the top is the phone or ISDN jack or second Ethernet connection.
• At the bottom are the configuration switches, the attachment unit interface
(AUI) connection, the network cable connection (such as Ethernet LAN hub),
and the power supply connector.
Figure 2

Figure 2 Rear panel of the Instant Internet 100 unit

300866-G
illustrates the rear panel of the unit.
Analog, ISDN,
or 2nd Ethernet
connection
Telco Line, or ISDN
1 2 3 4 5 6 7 8
Configure
AUI
Configuration AUI
switches connection
If you have a dual-Ethernet unit, the second Ethernet connection replaces
the phone or ISDN jack at the top of the unit.
Warning: The Instant Internet unit contains a lithium battery. There is a
danger of explosion if the battery is replaced incorrectly. The battery
should be replaced only by factory authorized personnel.
DC power
Ethernet
10 Mbps
DC
Ethernet
connection
9827EB