Nortel BayStack 100 Setting Up page 37

3
Turn on your unit by plugging it into the wall outlet.
The LEDs on the front of your unit flash and then glow steadily amber,
including the Power LED, when they completely match the sequence for the
selected switch settings.
Note: If you used the switch settings in
password and configuration switch settings, the Power LED glows amber
and LEDs 1–8 flash red in the sequence of the selected switch settings.
4
Turn off your unit by unplugging the power cord from the wall outlet.
5
Reset the switches for normal operation.
Normal operation is when all the switches are in the off position. Refer to
"Switch settings for normal operation" on page
6 Turn on your unit by plugging the power cord into a wall outlet.
Chapter 4 DIP switch settings
Table 5
34.
Setting Up the BayStack Instant Internet 100 Unit
to disable the reset
37