Mars Comfort-Aire Century VCD24 SA Series Installation Manual page 23

Installation and Operation Manual - VCDxxSA
Step 3
Remove the terminal block and power wires,
loosen the screws, and remove the electric
auxiliary heating cover.
Step 4
Install the electric auxiliary heating assembly
the front, and note that the support assembly
must lock into the support holes in the back
of the cabint.
shell
assembly
hole
This figure shows
the top view
perspective
Step 5
Tighten the mounting screws.
Step 6
Wire according to the wiring nameplate.
Apply the wiring diagram to the inside cover
wiring is completed for future reference and
maintenance.
Step 7
Install the upper cover,and the silicone breaker
cover.
Step 8
After installing the electric auxiliary heat module,
apply the circuit breaker label near the silicone
breaker cover that was just applied.
22
screws.