Mars Comfort-Aire Century VCD30 SA Series Manual
Hyper heat single-zone
Hide thumbs
Also See for Comfort-Aire Century VCD30 SA Series:
- Installation manual (49 pages) ,
- Installation and owner's manual (52 pages) ,
- Owner's manual (16 pages)
Related Manuals for Mars Comfort-Aire Century VCD30 SA Series
Summary of Contents for Mars Comfort-Aire Century VCD30 SA Series
- Page 1 REMOTE CONTROL MANUAL Hyper Heat Single-Zone Models VCD18, 24, 30, 36, 48, 60 SA Series 517.787.2100 • www.marsdelivers.com...
-
Page 2: Table Of Contents
Remote Control Manual - VCDxxSA Table of Contents Remote Controller Specifications ............02 Handling the Remote Controller ............03 Buttons and Functions ..............04 Remote Screen Indicators ..............08 How to Use Basic Functions ............09 How to Use Advanced Functions ..........11... -
Page 3: Remote Controller Specifications
Remote Control Manual - VCDxxSA Remote Controller Specifications RG10A(D2S)/BGEF, RG10A(D2S)/BGEFU1,RG10A1(D2S)/BGEF, RG10A2(D2S)/BGEFU1, RG10A2(D2S)/BGCEFU1, RG10A2(D2S)/BGCEF, RG10A10(D2S)/BGEF, RG10B(D2)/BGEF, RG10B1(D2)/BGEF, RG10B2(D2)/BGCEF,RG10B10(D2)/BGEF，RG10B10(D2)/BGCEF, RG10Y1(D2)/BGEF,RG10Y2(D2S)/BGEF 3.0V( Dry batteries R03/LR03×2) -5°C~60°C(23°F~140°F) NOTE: For models of RG10Y1 (D2)/BGEF,RG10Y2(D2S)/BGEF, If the unit is turned off under COOL, AUTO or DRY mode with the set temperature less than 24 C, the set temperature will be automatically set to 24 C when you turn on the unit again. -
Page 4: Handling The Remote Controller
Remote Control Manual - VCDxxSA Handling the Remote Controller Inserting and Replacing Batteries NOTES FOR USING REMOTE CONTROL Your air conditioning unit may come with two The device could comply with the local national batteries(some units). Put the batteries in the regulations. -
Page 5: Buttons And Functions
Remote Control Manual - VCDxxSA Buttons and Functions Before you begin using your new air conditioner, make sure to familiarize yourself with its remote control. The following is a brief introduction to the remote control itself. For instructions on how to operate your air conditioner, refer to the How to Use Basic Functions section of this manual. - Page 6 Remote Control Manual - VCDxxSA MODE ON/OFF Scrolls through operation modes Turns the unit on or off. as follows: AUTO COOL DRY HEAT FAN TEMP Increases temperate in NOTE: HEAT mode is not 1°C (1°F) increments. supported by the cooling only Max.
- Page 7 Remote Control Manual - VCDxxSA ON/OFF MODE Turns the unit on or off. Scrolls through operation modes TEMP as follows: AUTO COOL Increases temperate in DRY HEAT FAN 1°C (1°F) increments. NOTE: HEAT mode is not Max.
- Page 8 Remote Control Manual - VCDxxSA MODE ON/OFF Turns the unit on or off. Scrolls through operation modes as follows: AUTO COOL TEMP DRY HEAT FAN Increases temperate in NOTE: HEAT mode is not 1°C (1°F) increments. supported by the cooling only Max.
-
Page 9: Remote Screen Indicators
Remote Control Manual - VCDxxSA Remote Screen Indicators Information are displayed when the remote controller is power up. Breeze Away display(some units) Active clean feature display Fresh feature display Sleep mode display Follow me feature display Wireless control feature display(some units) Transmission Indicator Low battery detection display(If flashes) Lights up when remote... -
Page 10: How To Use Basic Functions
Remote Control Manual - VCDxxSA How to Use Basic Functions ATTENTION Before operation, please ensure the unit is plugged in and power is available. AUTO Mode Select AUTO mode Set your desired temperature Turn on the air conditioner MODE NOTE: 1. - Page 11 Remote Control Manual - VCDxxSA Setting the TIMER TIMER ON/OFF - Set the amount of time after which the unit will automatically turn on/off. TIMER ON setting Press TIMER button to initiate Press Temp. up or down button for Point remote to unit and wait 1sec, the ON time sequence.
-
Page 12: How To Use Advanced Functions
Remote Control Manual - VCDxxSA How to Use Advanced Functions Swing function Press Swing button Swing Swing The horizontal louver will swing up and down Keep pressing this button more than 2 seconds, automatically when pressing Swing button. the vertical louver swing function is activated. Press again to make it stop. - Page 13 Remote Control Manual - VCDxxSA ECO/GEAR function Press this button to enter the energy efficient mode in a sequence of following: GEAR(75%) GEAR(50%) Previous setting mode ECO..Note:This function is only available under COOL mode. ECO operation: Under cooling mode, press this button, the remote controller will adjust the temperature automatically to 24 C/75 F, fan speed of Auto to save energy (only when the set temperature is less than 24 C/75 F).
- Page 14 Remote Control Manual - VCDxxSA Silence function Keep pressing Fan button for more than 2 seconds to activate/disable Silence function(some units). Due to low frequency operation of compressor, it may result in insufficient cooling and heating capacity. Press ON/OFF, Mode, Sleep, Turbo or Clean button while operating will cancel silence function.
- Page 15 Remote Control Manual - VCDxxSA SET function Press the SET button to enter the function setting, then press SET button or TEMP or TEMP button to select the desired function. The selected symbol will flash on the display area, press the OK button to confirm.
- Page 16 7/2023...