Table of Contents
Advertisement
Maintenance
Maintenance
NOTE: In the event of a hardware issue, always contact your installer first.
Damage caused to the equipment by misuse, lack of maintenance, inappropriate
maintenance or modification is not covered by the manufacturer warranty.
WARNING: Electrical Power
The charger enclosure does NOT need to be opened for routine maintenance tasks
but, if opened for more thorough testing/maintenance, it must only be done by an
appropriately qualified electrical engineer.
1. Regularly clean the external surfaces of the equipment with a damp cloth.
CAUTION: Equipment Damage
To avoid damage to the surface finish, and/or internal components do NOT use:
Abrasive materials.
Mineral or petroleum solvents / degreasers.
Hose pipes, Jet washers or Steam cleaners.
2. Regularly inspect the exterior of the equipment for visual damage.
If damage affects safety, isolate the equipment and prevent its use until appropriate
repairs have been completed.
3. Any externally installed switchgear may be tested by pressing its built-in test button.
When pressed the switchgear should operate to stop the supply of power to the charger.
If the switchgear fails to operate correctly, isolate the equipment and prevent its use
until appropriate repairs have been completed.
If required, an appropriately qualified electrical engineer may open the enclosure to perform
observations and tests.
4. The charger and any additional externally installed switchgear should be electrically
inspected (tested) by an appropriately qualified electrician in accordance with the
legislation for the installation location.
If the equipment fails the test, isolate the equipment and prevent its use until
appropriate repairs have been completed.
5. Whenever the enclosure is opened, check the security of accessible cable terminals
before closing the enclosure. Temperature changes during the year and when charging,
and movement of cables during maintenance may cause cables/terminals to become
loose.
Make sure power to the charger is OFF.
Check the security of ALL accessible terminals.
Tighten any terminals that appear loose.
6. Make sure the enclosure is closed securely after work is done.
Universal Electric Vehicle Chargepoints
Page 15 of 17
QUBEVM-V01-R0 Installation and Operation Manual
February 2023
Advertisement
Table of Contents
