Table of Contents
Advertisement
Installation
Installation Procedure
NOTE: All electrical work must be performed in accordance with the applicable Electrical Wiring
Regulations for the region of use.
CAUTION: Equipment Damage
During the next steps, the charger front panel will be removed. Take care to not damage or
strain cables or cable connections that run between the enclosure and the front panel.
1. Remove the QubEV from the packaging.
2. Release the fixings that secure the front panel to the rear enclosure.
3. Carefully lift the front panel away from the rear enclosure to access to the interior.
CAUTION: Equipment Damage
The front panel is connected to the charger by electrical cables. Take care not to damage,
strain, or disconnect the cables. At the end of the procedure, make sure all connections are
secure before refitting the panel.
4. Visually inspect the QubEV and internal components.
Any components that may have come away from the DIN rail in transit must be
refitted to the rail if there is no damage to the component or its securing
mechanism.
IMPORTANT: Items damaged in transit must first be reported to the courier and then
to the supplier.
Where possible, photographic evidence of package and/or unit damage
should be provided.
Incorrect or damaged units must NOT be installed. Contact your supplier to
discuss replacement or repair.
5. Make note of the location of the incoming power terminals within the enclosure. This will
help when positioning the unit to meet the customer's needs.
6. Remove the mounting template from the packaging.
7. Use the mounting template to mark the mounting position.
Place the mounting template onto the mounting location (wall).
Make sure the template is flat against the wall and is orientated correctly and is level.
Mark the 4 fixing holes onto the surface of the wall.
8. Drill the 4 marked fixing holes and insert the wall plugs.
9. Cut a neat hole in the charger body to allow entry of the power cable.
Ideally, the cable should enter the unit from below or through the back of the
enclosure.
A suitable cable gland must be used to maintain the IP integrity of the unit.
10. Make sure all debris is removed from the charger enclosure.
11. Secure the charger enclosure to the mounting location with the appropriate fixings.
Universal Electric Vehicle Chargepoints
Page 11 of 17
QUBEVM-V01-R0 Installation and Operation Manual
February 2023
Advertisement
Table of Contents
