qubev EVON0040 Installation & Operation Manual page 13

NOTE: All electrical work must be performed in accordance with the current Electrical Wiring
Regulations.
CAUTION: Equipment Damage – Sensitive Equipment
If you will be performing insulation resistance tests on the power supply cables, it is advised
to be done BEFORE connecting the cable to the charger. The high voltages applied during
the test may damage sensitive components if tested after the cable is connected.
12. Route the power supply cable to the appropriate length to be able to connect to the
terminals.
13. Terminate the supply cable in the appropriate manner and connect to the pedestal as per
the schematic.
1-phase models will use the terminals L1, N and E.
3-phase models will use the terminals L1, L2, L3, N and E.
14. Make sure ALL accessible cable connections are secure and have not become loose or
damaged in transit or during installation.
15. Make sure ALL debris is removed from the front and rear halves of the enclosure and that
no debris is present on any of the components.
IMPORTANT NOTE:
It is the responsibility of the installing engineer to make sure, that all accessible cable
terminations throughout this product are secure and tight and have not become loose,
strained, or disconnected during transit and/or installation.
QUBEVM-V01-R0 Installation and Operation Manual
February 2023
Installation
Universal Electric Vehicle Chargepoints
Page 12 of 17