Table of Contents
Advertisement
4
Electrical Installation
CAUTION – RISK OF ELECTRIC SHOCK: Only qualified individuals should perform power
routing and termination to the system. It is the responsibility of the electrical contractors
to ensure that all electrical work meets or exceeds local and national codes. Failure to
follow installation guidelines will result in audible noise on the sound system and possible
damage to internal components.
Note: This product is not provided with mains disconnect. Customer shall provide
disconnect at base of sound system location that meets or exceeds local and
national electrical codes.
Power/Signal Connections
Reference Drawings:
System Riser; Electrical & Audio Notes ............................................................. DWG-985713
Schematic; Control Enclosure 1500HD 120VAC ........................................... DWG-5103751
System Riser; 1500HD ........................................................................................ DWG-5115728
DWG-5115728 in Appendix A details power and signal connections between the fiber
box, control enclosure, and sound cabinet of the Sportsound 1500HD sound system. Refer
to Figure 11 for component and connection locations within the control enclosure and
DWG-5103751 in Appendix A for detailed wiring schematics.
Notes:
•
Use a flathead screwdriver to unlock the latch on the enclosure door. A padlock is provided
with the control enclosure that may need to be removed.
•
Power/signal connections should not be drilled through the top of the enclosure. If this is
unavoidable, a weather-sealed connection is required.
Fan
(115V = B-1045)
Analog Signal - TRX1
(From Fiber Conversion Box)
POE Switch
(A-5110612)
Signal OUT - TBL2
(To Sound Cabinet)
Figure 11: Control Enclosure Components & Connections (Covers Removed)
Power IN -
TBL1 & GND
Electrical Installation
8
Amplifers @2
(A-5082165)
Fiber Splice Point - FPP2
(From Fiber Conversion Box)
Line Filter
(Z-1007)
Power Supply
(A-5099220)
Advertisement
Table of Contents
Troubleshooting
