Table of Contents
Advertisement
Safety Notes
These Safety Notes include important information about installation, use, and maintenance.
•
ONLY connect this product to a grounded and protected circuit.
•
DISCONNECT from power before cleaning or replacing the fuse.
•
DO NOT look at the light source when the product is on.
•
Make sure the power cord is not crimped or damaged.
•
Never disconnect this product from power by pulling on the cord.
•
When mounting this product overhead, ALWAYS use a safety cable.
•
DO NOT allow flammable materials close to the product when it is operating.
•
DO NOT touch the product's housing when it is on because it will be hot.
•
The voltage of the outlet to which you are connecting this product must be within the range
stated on the decal or rear panel of the product.
•
DO NOT open this product. It contains no user-serviceable parts.
•
DO NOT submerge this product (IP65). Regular outdoor operation is fine.
•
Not for permanent outdoor installation in locations with extreme environmental conditions.
This includes, but is not limited to:
•
Exposure to a marine/saline environment (within 3 miles of a saltwater body of water).
•
Where the normal high or low temperatures of the location exceed the temperature ranges
in this manual.
•
Locations that are prone to flooding or being buried in snow.
•
Other areas where the product will be subject to extreme radiation or caustic
substances.
•
Always mount this product in a location with adequate ventilation, at least 20 in (50 cm) from
adjacent surfaces.
•
Be sure that no ventilation slots on the unit's housing are blocked.
•
Never connect this product to a dimmer or rheostat.
•
Never carry the product by the power cord. Use only the hanging bracket or handle to carry
this product.
•
The maximum ambient temperature is 104 °F (40 °C). Do not operate this product at higher
temperatures.
•
In the event of a serious operating problem, stop using immediately.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Keep this User Manual for future use. If the product is sold to someone else, be sure that
they also receive this document.
2
Before You Begin
Intimidator Spot 360X IP User Manual Rev. 1
Advertisement
Table of Contents
