Advertisement
F INAL CHECKS & R OA D T EST
1. Install your pedals as per the manufacturer's instructions.
2. Then check the tire pressure and inflate as per the manufacturer's
recommendation.
3. Adjust the saddle height as necessary, and torque the seatpost clamp bolt to 6
N.m using a torque wrench. Ensure the seat post minimum insertion depth of
10cm is achieved.
4. Put on your shoes and helmet and take your new bike out for a road test. Always
wear a helmet when you ride your bicycle.
5. Check the operation of the brakes, derailleurs, and steering.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD LEAD TO SERIOUS INJURY OR DEATH.
WARNING
24
E N JOY YO U R
N EW R ID E !
Q UICK R EF E R EN CE S PECS
Torque Spec: 6 N.m.
S EAT P OST
Use a torque wrench with 5mm
CL A M P
hex attachment
Torque Spec: 10 N.m.
T HRU
Use a 6mm Hex Tool
AXLES
Torque Spec: 5-6 N.m. depending
ST E M
on stem make and model. Check
stem for torque spec indications or
B OLTS
check with manufacturer.
Max 700C x 48mm
T I RE
Tire clearance varies based on
S I ZI N G
internal rim width
25-35 PSI
TI RE
Adjust as conditions and
PRES SU RE
equipment allow
VENTUM RACING .COM
Advertisement
