Page 2
Congratulations on your purchase of the Ventum NS1, your Aero All-Road Performance Bike! Get ready to experience a bike that is totally unlike any other on the road today. Your new Ventum NS1 combines forward thinking design with the most advanced technologies available, to shatter the notion that a road bike can be either lightweight or aerodynamic.
FRAME DIAGRAM Please carefully inspect the image. It gives you a thorough break down of the names of the tubes that the frame/ fork consist of and the components that this bike uses. Please refer back to this image as needed. Top Tube Handle Bar Fork...
Page 14
SEAT POST INSTALLATION 1. Plug Di2 cable into seat post battery, you should hear a click. 2. Insert the seat post into the frame. Ensure the minimum insertion depth of 10 cm is achieved. 3. Torque the seat post clamp bolt to a minimum of 6 N.m. Temperature, moisture, and contaminants can affect the seat post clamp.
WHEEL INSTALLATION Unscrew the thru axles from the frame and fork using a 6mm hex tool...
Page 19
WHEEL INSTALLATION Remove the spacers from the brake calipers...
Page 20
WHEEL INSTALLATION Install the wheels ensuring the rotor lines up between the brake pads...
Page 21
WHEEL INSTALLATION Secure the wheels by re-installing the thru axles. Torque to 12 N.m. WARNING FAILURE TO FOLLOW THESE INSTRUCTIONS COULD LEAD TO SERIOUS INJURY OR DEATH.
FINAL CHECKS & ROAD TEST 1. Install your pedals as per the manufacturer’s instructions. 2. Check the tire pressure and inflate as per the manufacturer’s recommendation. 3. Adjust the saddle height as necessary. Ensure the seat post minimum insertion depth of 10 cm is achieved. 4.