Advertisement
SE AT P OST I NSTA LL AT I O N
1. Plug Di2 cable into seat post battery, you should hear a click.
*Step #1 only required for Shimano GRX Di2 builds.
2. Insert the seat post into the frame. Ensure the minimum dept of depth of 10 cm is
achieved. Carbon paste is not necessary. If you choose to use carbon paste, only
apply to the back and/or sides of the seatpost, making sure to avoid the front side
and seat post clamp.
3. Torque the BLACK seat post clamp bolt to a minimum of 6 N.m. using a torque
wrench. Do NOT adjust the silver retaining bolt. Temperature, moisture, and
contaminants can affect the seat post clamp.
If necessary, it can be torqued up to 8 N.m.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD LEAD TO SERIOUS INJURY OR DEATH.
1 4
Step 1
SE AT P OST I N STAL L AT I ON
Step 2
Towards handlebar
Black Seatpost Clamp bolt
(5mm hex). Torque to 6N.m.,
loosen to raise/lower seatpost
1 5
Step 3
Silver retaining bolt
(DO NOT ADJUST)
Advertisement
